Blodgett SG3240 Serie Manual Del Operario página 12

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 259
Installation
Oven Assembly
STACKING THE OVENS (if applicable)
1. Install the supports on the bottom unit as de-
scribed.
2. Have several persons carefully lift the oven off
the pallet and set it onto the casters.
3. Engage the brakes on the front casters.
4. Rest the top oven on its back. Install the four
oven alignment pins into the outside corner
mounting holes provided on the bottom of the
oven.
5. Assemble the three long stacking trim pieces
on the top of the bottom (or middle) oven.
Align the holes over the holes for the align-
ment pins.
6. Have several persons carefully place the
upper oven on top of the lower oven. Align the
alignment pins with the knock-out holes in the
top the lower oven.
Heat
Shield
and
Brackets
Stacking
Plate
7. Place the stacking plate on top of the electrical
box on the bottom unit.
NOTE: The back of the plate should line up
8. Loosen the three screws on the top of the elec-
trical box side panel on the lower oven.
9. Slide the slots in the bottom of the stacking
trim over the loosened screws. Tighten the
screws.
10. Attach the stacking trim to the side of the
stacking plate with the screws provided.
11. Attach the heat shield brackets to the bottom
of the control tunnel using screws, lockwash-
ers and washers.
NOTE: The stops on the brackets should be
12. Slide the heat shield into the brackets.
Oven
Alignment
Pin
Alignment
Stacking
Pin
Trim
Figure 6
10
with the back of the electrical box.
located away from the control.
Stacking
Trim
Stacking
Plate
Electrical
Box
Heat Shield
Brackets
Heat
Shield
Stacking
Trim
Oven

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Sg3240g/aaSg3240e/aa

Tabla de contenido