Electrical Connection - Blodgett SG3240 Serie Manual Del Operario

Before making any electrical connections to this
unit, check that the power supply is adequate for
the voltage, amperage, and phase requirements
stated on the rating plate.
NOTE: Electrical connection must be performed
by a qualified installer only.
NOTE: The electrical installation must comply
with the national local codes and installa-
tion requirements.
A strain relief for the supply cord is required. The
installer must provide a supply cord bushing that
meets all Local and National Installation stan-
dards.
Wiring diagrams accompany this manual and are
attached inside the electrical box and on the rear
of the oven.
SG3240G
The SG3240G requires a 5 Amp, 50HZ, 1Φ,
230VAC, 3 wire service consisting of L1, N and
ground.
Connect the oven to a separate 230V, 50 hz power
supply with a supply cord and plug or rigid con-
nection and circuit breaker. If a supply cord with
plug is used the appliance must be positioned so
that the plug is accessible. The circuit breaker or
plug must disconnect all poles, including neutral,
with a contact separation of at least 3 mm.
WARNING!!
Incorrect single phase wiring with other
than 208-240 VAC may result in extensive
damage to electrical components and fire
in the electrical box.
Installation
SG3240E
The SG3240E requires a 41.5 amp, 50 HZ, 3Φ
WYE, 230/400 VAC, 5 wire service consisting of
L1, L2, L3, Neutral and ground.
Connect the oven to a separate 230V, 50 hz power
supply with a supply cord and plug or rigid con-
nection and circuit breaker. If a supply cord with
plug is used the appliance must be positioned so
that the plug is accessible. The circuit breaker or
plug must disconnect all poles, including neutral,
with a contact separation of at least 3 mm.
Connect L1 + L2 + L3 + neutral + ground.
THE BLODGETT OVEN COMPANY CANNOT AS-
SUME RESPONSIBILITY FOR LOSS OR DAMAGE
SUFFERED AS A RESULT OF IMPROPER IN-
STALLATION.
23

Electrical Connection