Gas Connection - Blodgett SG3240 Serie Manual Del Operario

GAS HOSE RESTRAINT
If the oven is mounted on casters, the installer a
commercial flexible connector with a minimum of
1.9 cm (3/4") inside diameter must be used along
with a quick connect device.
The gas hose restraint (heavy gauge cable), sup-
plied with the oven, must be used to limit the
movement of the unit so that no strain is placed
upon the flexible connector. Locate the restraint as
follows:
The restraint bracket should be fastened to the
D
left rear oven support. See page 8 for installa-
tion of the restraint bracket.
The restraint should be short enough to prevent
D
any strain on the connector. See Figure 19 View
A for length adjustment detail.
With the restraint fully stretched the connector
D
should be easy to install and quick connect.
View A
Tighten after
adjusting length of
cable
The permanent end of the restraint should be at-
tached without damaging the building. DO NOT
attach the restraint to the gas piping or electrical
conduit! Use anchor bolts in concrete or cement
block. On wooden walls, drive hi test wood lag
screws into the studs of the wall.
WARNING!!
If the restraint is disconnected for any
reason it must be reconnected when the
oven is returned to its original position.
The restraint and quick connect must conform
with Local and National installation standards.
Local installation codes and/or requirements may
vary. If you have any questions regarding the
proper installation and/or operation of your Blod-
gett oven, please contact your local distributor. If
you do not have a local distributor, please call the
Blodgett Oven Company at 0011-802-860-3700.
Gas Supply Line
Socket
Plug
Quick Connect
Figure 19
21
Installation

Gas Connection

Socket
Gas
Hose
(See View A)