Genie CHAINLIFT 1022 Manual De Instrucciones página 10

I
Rail Assembly for CHAIN DRIVE OPENER
Jocat® Bag O t_-o£ Box_ 1
3. Remove the two rail sections that are not
connected to the chain and place them on
floor (Fig. 1-2, A).
4. Carefully remove the third rail section with
chain and plastic sleeve. Place rail section on
floor and extend chain straight out
(Fig. 1-2, B). Chain and rail should extend
approximately 7 feet.
5. Remove wire ties and plastic bag from chain.
Leave chain extended straight out on floor.
Avoid kinks in the chain by careful handling and
keeping chain flat on the floor.
6. Align the three rail sections by pulling the
chain straight and wrapping it around the
chain tensioner pulley (Fig. 1-3 & 1-4).
7. Attach the two rail clamps to the rail section
joints with (4) bolts and nuts. After both rail
clamps have been assembled to the rail sections,
securely tighten the bolts and nuts.
CHAIN DRIVE RAILS
BELT DRIVE RAILS
Belt Rail
Rail Assembly for BELT DRIVE OPENER
Jocat® Bag 0 _<:}n Box_ f
3. Remove the two rail sections that are not
connected to the belt and place them on floor
(Fig. 1-2, A).
4. Carefully remove the third rail section with
belt. Place rail section on floor, remove ties on
belt and extend belt straight out (Fig. 1-2, B).
Avoid twists and kinks in the belt by careful
handling and keeping belt flat on the floor. Belt
and rail should extend approximately 7 feet.
5. Align the three rail sections by pulling the belt
straight and wrapping it around the tensioner
pulley (Fig. 1-3 & 1-4).
6. Attach the two rail clamps to the rail section
joints with (4) bolts and nuts. After both rail
clamps have been assembled to the rail sections,
securely tighten the bolts and nuts.
FIG. 1-2 Split Rail sections.
CHAIN
Rall Clam )s
Rail with chain
Rail Clamp Bolts
Cha
Power Head
Trolley Slide
Rail Clam Nut!
Center Ra
Release
Rnol) Rail with belt
FIG. 1-3 Split Rail assembly.
Wrap around tensioner pully
FIG. 1-4 Mount chain/belt to tensioner pulley.
0 PN# 36420Supplement, 10/27/2008