Genie CHAINLIFT 1022 Manual De Instrucciones página 20

I
closing force is set too high.
, Never increase the door closing force above the
minimum required to move the door.
described on page 22 and in Section 10.
The OPEN (UP) and CLOSE (DOWN) door positions
are controlled by making the adjustments on the
panel located on the bottom of the power head. The
adjustments that can be made are:
• Close Travel Limit,
• Open Travel Limit,
Maximum Closing Force
Maximum Opening Force
Transmitter Programming
ENGAGE CHAIN/BELT CONNECTOR TO
CARRIAGE
1. Press and hold the "Close Travel Limit" [] button
until the chain or belt connector advances and
engages to the Carriage Assembly (FIG 6-2).
Limit Controls location
on power head.
\
\
\
LED
ndicator Lignx
o
3arag_ Door
Ooex
Ooer Set Limit _o Force
,,,,, Travel Limit Button
\_ I_IlS_ [ OPEN COntrOl
ustmen£
LEARN MANUAL LIMIT FORCE
Code
CODE
Close
CLOSE
Down Force
Button Close
Travel Limit Set Limit Contro
3utton Adjus_men_
FIG. 6-1 Limit controls.
20
CLOSE TRAVEL LIMIT
1. Press and hold the "Close Travel Limit" [] button
until the door is fully closed.
2. You can quickly press and release the "Close
Travel Limit" [] button to move the door in small
increments. You can also use the "Open Travel
Limit" [] button to move the door slightly in the
UP direction.
3. Door is fully closed when the bottom edge of door
presses firmly onto the ground.
4. Once the door is in the desired position, press and
release the "Down SET Limit" [] button. The
LED indicator light light will blink green once. This
stores the closed position in memory.
OPEN TRAVEL LIMIT
1. Press and hold the "Open Travel Limit" [] button
to move the door to its fully opened position. This
starts the opener moving in the UP direction.
2. Hold the "Open Travel Limit" [] button until the
door is in the fully opened position that you desire,
then release this button.
3. You can quickly press and release the "Open
Travel Limit" [] button to move the door in small
increments. You can also use the "Close Travel
Limit" [] button to move the door slightly in the
DOWN direction.
4. Once the door is in the desired position, press
and release the "Open SET Limit" [] button.
The LED indicator light will blink green twice.
This stores the opened position in memory.
La_cr
Movement
Carriage Assembly
J
/
Chain Connector
Movement
=alcn
_ovement
Carriage Assembly
/
Belt Connector
Movement
FIG. 6-2 Engage Chain/Belt Connector to Carriage.
Operation of the opener without the Chain or Belt
Con nector engaged to the Carriage Assembly will
result in damage to rail components including the
rail pulley.
PN# 36420Supplement, 10/27/2008