Genie CHAINLIFT 1022 Manual De Instrucciones página 23

3, During programming; the door opener could
begin to run; so keep people and objects away
from the moving door and its partsl To keep the
door from moving, close the door and
disconnect it from the Opener by pulling the
Emergency Release.
HOTE:Foy'Yemoeco_o
oc oBox"
s
la. Single Button Remote Programming.
bu__ons
• Locate learn code button and indicator LED
on the power head (next to force adjustment
screws) (Fig. 7-1).
• Press and release learn code button.
-Indicator LED will blink RED at a rate of twice
per second.
• Within 30 seconds, push remote control
button once.
-Indicator LED will stop blinking and stay on.
• Press remote control button again.
-Red LED will go out. Remote is now
programmed.
lb. Multi Button Remote Programming.
HO7C_! Ssch bu _o_ on s,mu S,,b_,z ton _'<<mo_A_, is
desJ_Fnodh:wus_?wJds I <foo_: You csmo
c_ ' you prc,{i;r_n 1 M,A on 80 c,pon_ e 2 d<;o_s.
_<,,_nsmJI'e£s or wh'_ ess chs_v]cos.
NOTE: To program a
....
Homelinl_ and Car2U _
device follow the Homelinl_ or Car2tP
instructions in your car owner's manual
This device complies with FCC Part 15 and RSS 210
of Industry Canada. This equipment has been tested
and found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a residential
installation This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However. there is no guarantee that interference will
not occur in a particular installation If this equipment
does cause harmful interference to radio or television
reception, which may be determined by turning the
equipment OFF and ON, the user is encouraged to
try to correct the interference by one or more of the
following measures:
• Re-orient or relocate the receiver antenna.
• Increase the separation between the opener
and receiver.
• Connect the opener into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult your local dealer.
2. Operating.
• Press remote button once.
- Door will move.
• Press button again.
- Door will stop.
• Press button again.
-Door will move in opposite direction.
£/,£y open o_ h.,_y c_o,s_:d F;_o,s
_io_',
1. Clear memory.
• Press and hold learn code button (on power
head) for 10 seconds or until the red blinking
indicator LED goes out.
• Program remaining or new remote controls as
done previously. Your door opener will no
longer recogmze any signal received from the
missing remote control, or any other which has
not been reprogrammed.
LED Open
Indicator Light Open Set Limit
,\ Travel Limit Button
\
To
Garage Door
Up Force
OPEN control
l- ;u tme
LEARN MANUAL LIMIT FORCE
BCtdtoe n CODE Close Close CLOSE D_ownF ....
Travel Limit Bet Limit Control
Button Adjustment
FIG. 7-1 Learn code button and LED
PN# 36420Supplement, 10/27/2008
I
23