Genie CHAINLIFT 1022 Manual De Instrucciones página 28

I
OFF OFF Normal operation None required
• Transmitter has not learned • Push button to program
2 BLINKS, Pause
(Repeat)
4 BLINKS, Pause
(Repeat)
1 BLINK, Pause
(Repeat)
Programming incomplete
Wire to power head or wire
connection at power head is
bad.
• Sensors out of alignment
• Continuous obstruction
• Push button wire short
• Push button wires reversed
in power head connector.
• Set UP LIMIT programming
• Check power head wiring, check
connections,
- Replace or repair
• Check Source & Sensor alignment
• Check for obstruction
• Check push button and wiring.
Staples can cut insulation and shorts
wires. Repair or replace push button
and/or wiring.
- Contact The Genie Company at
1-800-35-GENIE
• Reverse wire placement in power
head connector. (See section D)
8 PN# 36420Supplement, 10/27/2008