Descargar Imprimir esta página

Important Safety Instructions - Genie CHAINLIFT 1022 Manual De Instrucciones

Ocultar thumbs Ver también para CHAINLIFT 1022:

Publicidad

IMPORTANT SAFETY INSTRUCTIONS
,
2.
3.
o
uce
rls
READ AND FOLLOW ALL INSTRUCTIONS.
severeinjury or
Never let children operate or play with the door controls. Keep the remote control away from children.
Always keep the moving door in sight and away from people and objects until the door is completely
closed. NO ONE SHOULD
CROSS THE PATH OF THE MOVING
DOOR.
4. NEVER GO UNDER A STOPPED,
PARTIALLY OPEN DOOR.
5. Test opener monthly. The door MUST reverse on contact with a 1-1/2" high object (or a 2" x 4" board
laid flat) at the center of the doorway on the floor. After adjusting either the force or the limit of travel,
retest the door opener. Failure to adjust the opener properly may cause severe injury or death.
6. When possible,
use the emergency
release only when the door is closed. Use caution when using this
release with the door open. Weak or broken springs are capable of increasing the rate of door closure
and increasing the risk of severe injury or death.
7. KEEP DOORS PROPERLY
BALANCED.
See your garage door Owner's Manual. An improperly
balanced door increases the risk of severe injury or death. Have a trained door system technician
make
repairs to cables, spring assemblies,
and other hardware.
8SAVE THESE INSTRUCTIONS.
If you have any questions, please do not hesitate to contact Genie ®customer service at:
I
1.800.354.3643
I
Garage door hardware
(springs, cables,
brackets,
pulleys, etc.) are under extreme
pressure and tension.
DO NOT attempt to repair or adjust door springs
or any hardware, and DO NOT OPERATE garage
door automatically
or manually
if door is
improperly balanced or springs are broken.
- CONTACT A TRAINED DOOR SYSTEM
TECHNICIAN.
,
Door balance.
• With the door closed, pull emergency release
knob (Carriage Lock) towards the opener to
release door from carriage assembly.
• Raise door manually approximately 3'- 4' and
release.
- Door should remain stationary or move very
slightly.
- If door moves quickly, CONTACT A TRAINED
DOOR SYSTEM TECHNICIAN.
• Close the door.
• Pull emergency release knob towards door to
engage carriage.
- Operate door using remote.
- Door will re-attach itself to carriage assembly.
2. Contact reverse.
• Place a 2"x 4" board laid flat on floor.
- In center of garage door opening.
• Close door by using wall button or
remote control.
- Door fails to reverse on contact with board
(See section [] "CONTACT REVERSE.")
- Opener still fails
CONTACT THE GENIE COMPANY OR AN
AUTHORIZED
GENIE ® DEALER.
3. Safe-T-Beam ®System.
• Red LED blinks.
- check alignment (See section 0).
I

Publicidad

loading

Este manual también es adecuado para:

Chainlift 1024Chainlift 1042Beltlift 1022Beltlift 24Beltlift 42