Technical Data; Distance Measurement; Power Source - Hilti PD-C Manual De Instrucciones Original

3.5 Technical data

3.5.1 Distance measurement

Note
Distance and inclination measurement accuracy: Influences such as high temperature fluctuations,
dampness, shock, dropping, etc. can affect the accuracy of the tool. Unless stated otherwise, the tool
was adjusted or calibrated under standard ambient conditions (MIL-STD-810G). As a basic principle,
when taking distance measurements an additional distance-dependent error of 0.02 mm per meter is
to be taken into account. The reference for inclination measurements is the underside of the tool.
Operating modes
Distance measurement accuracy (2σ, standard
deviation)
Inclination measurement accuracy (2σ, standard
deviation)
Beam divergence
Measuring range with target plate
Minimum distance for aiming with the laser
point and cross hairs without use of the zoom
function
Minimum distance for aiming with the laser
point and cross hairs at the maximum zoom
setting
3.5.2 Touchscreen
Indicators
Touchscreen diagonal size

3.5.3 Power source

Li­ion battery
Rated voltage
Capacity
Standby time
Length of time until the automatic sleep mode is
activated
Battery life under normal operating conditions,
display switched on
Charging time (depending on battery charger
and charging cable)
Battery charger input voltage
Battery charger input frequency
Battery charger rated current
Battery charger output voltage
Charging current
Charging cable plug standard
42
• Single measurements
• Range (multiple) measurements
±1.0 mm
±0.3°
0.20 mrad ... 0.45 mrad
0 m ... 200 m
(0 ft ... 656 ft)
> 2 m
(> 6 ft - 10 in)
> 5 m
(> 16 ft)
Continuous display of distance, operating status
and battery charge status
10.16 cm
(4.00 in)
Built-in
3.7 V
3,220 mAh
> 200 h
20 min
≈ 10 h
≈ 3 h
100 V ... 240 V
50 Hz ... 60 Hz
0.5 A
5 V
10 mA ... 2,100 mA
Micro-USB