Installing The Cable Glands (Optional, +H376) - ABB ACS355 Serie Manual De Instrucciones

Installing the cable glands (optional, +H376)

Note: The lead-throughs are only meant for sealing the enclosure. Do not use them
for grounding.
1. Remove the sticker labeled REMOVE BEFORE USE.
2. Tighten the cable glands that you want to use with their back nuts. The tightening
torque depends on the cable gland size. See
3. Lead the cable through the gland and tighten until the gasket of the lead-through
is tightly around the cable. The cable diameter depends on the cable gland size:
• M12: 3.5...7.0 mm
• M25: 9.0...17.0 mm
• M32: 11.0...21.0 mm
1
3
Tightening torques
2
37
on page 38.
Mechanical installation