SCHUBERTH SR2 Manual página 25

C. THE HELMET
CLOSING THE FACE SHIELD
To close the face shield, grip one of the finger tabs
and pull the shield down.
LOCKING THE FACE SHIELD
To lock the face shield when fully closed, move the
operating element towards the rear with a movement
of the hand. To release the face shield again, move the
operating element back to its original position.
URBAN POSITION
To ensure sufficient fresh air in the helmet when moving slowly (e.g. city
riding), you can set the face shield to the 'urban position' by means of the
locking operating element. To set urban position, start with the face shield
open and move the operating element towards the rear with a movement of
the hand. The catch pins of the face shield engage on the operating element,
creating a small gap between the face shield and face shield seal.
REPLACING THE FACE SHIELD
The face shield can be changed easily and with the convenient push-release
system. To replace the face shield, it is helpful to place the helmet on a flat
surface or on your lap while seated.
46
Removing the face shield
1. Close the face shield. Press the
button of the push-release face shield
mechanism on one side and hold it
down.
2. Move the face shield upwards until it is
released from its fixing.
3. Repeat steps one and two above on
the opposite side of the face shield.
Fitting the face shield
1. Using both hands, guide the catch
pins of the face shield into the recess
provided for them in the face shield
mechanism.
2. Apply light pressure directed towards
the helmet and a closing motion until
the face shield engages audibly.
3. Check the functioning of the face
shield mechanism by opening it until it
hits the end stop and then closing it
again.
EN
47