Reflective Panels - SCHUBERTH SR2 Manual

C. THE HELMET
VENTILATION DEVICE 4 –
INTERIOR AIR EXTRACTION
The SR2 is equipped with a constant air extraction
system. Air present in the interior and entering via
the ventilation is guided via channels towards the
rear of the helmet. The reduced pressure present
to the rear of the helmet ensures a constant
suction of the air from the inside through the air
outlets under the spoiler and in the special mesh
material in the neck cushion ensuring a comfortable
temperature inside the helmet.
VENTILATION DEVICE 5 – CHIN VENTILATION
The chin vent can be opened and closed with the controller on the chin.
The chin vent lets you regulate the amount of fresh air around the chin at
all times. The air flowing through the fresh air intake is directed through the
vents into the comfort cheek pads so that moisture and heat inside of the
pads is effectively diverted out of the helmet.
56
NO AIR

13. REFLECTIVE PANELS

Together with the silver reflective strips located laterally at the back of the
neck pad, the two reflective panels integrated into the left and right areas
under the visor plate help make the motorcycle rider more noticeable on
the road, especially in conditions of poor visibility. If the helmet is plain
(no decoration), the SCHUBERTH name also appears on the front and
back of the helmet in a reflective film.
Note:
Keep the reflective safety areas clean.
Note:
When riding in France, local law requires that further reflective safety
stickers be attached to the front, back and both sides of the helmet.
EN
57