Interconnections - Agilent Technologies Turbo-V 2K-G Serie Manual De Instrucciones

17 Technical Information

Interconnections

Interconnections
The following paragraphs describe the Turbo-V 2K-G
interconnections.
J1 – Remote I/O
Figure 12
This connector carries all the input and output sig-nals to remote
control the Turbo-V 2K-G.
It is a 15-pins D type connector; the available sig-nals are detailed in
the table, the following paragraphs describe the signal characteristics
and use.
Tab. 3
PIN N.
1
2
3
4
5
6
7
8
9
10
11
310/372
SIGNAL NAME
START/STOP (+)
START/STOP (-)
INTERLOCK (+)
INTERLOCK (-)
SPEED SETTING (+)
FAULT COMMOMN
SOFT START (+)
SET POINT
+24 Vdc
PURGE (+)
SET POINT
Turbo-V 2K-G Pumping System User Manual / 87-900-968-01 (G)
INPUT/OUTPUT
IN
IN
IN
IN
IN
OUT
IN
OUT
OUT
IN
OUT
ISOLATION
Optocoupled
Optocoupled
Optocoupled
Optocoupled
Optocoupled
Relay
Optocoupled
Relay
Transformer
Optocoupled
Relay