Display; Starting Your Watch (First Time); Setting Up Your Watch - Oregon Scientific SE833 Manual De Usuario

DISPLAY

1
2
3
4
5
6
7 8 9 10
1. : Key to press indicator
2. or : Indicates battery power is low or empty
3. / : 12 hour clock
4. : Press the key to exit
5. : Indicates up / down or upper / lower limit
6. : Indicates beep tone is off
7. : Indicates exercise timer is activated
8. : Indicates alarm is on
9. : Indicates heart rate signal is received or heart rate
chest belt is paired
10. : Indicates speed and distance signal is received or
foot pod is paired
11. : Indicates bike and cadence signal is received or
bike pod is paired
12.
13. : Indicates keypad is locked
13
OPERATING MODES
12

STARTING YOUR WATCH (FIRST TIME)

After removing the watch from the package, activate it by
pressing and holding MODE until the display is shown. The
11
watch will prompt you to set your user profile.

SETTING UP YOUR WATCH

IMPORTANT
• To ensure accurate calculations with your exercise, you
are strongly required to set the watch and user profiles
before exercising.
• Remember to set the profiles after every battery
replacement or reset.
NOTE
When the watch is left idle for 30 seconds during set
up, it will automatically exit.
3
: Resolutions per minute (unit of cadence)