Calibrating Paired Device; Calibrate By Running Or Walking - Oregon Scientific SE833 Manual De Usuario

REMOVE".
4. Press SET.
5. Press ST/LAP/+ to select which device to delete.
6. Press SET to confirm selection.

CALIBRATING PAIRED DEVICE

The watch will not show "CAL DEVICE" if no device is
paired.
You can calibrate by running, walking or inputting parameter.
The parameter is the same value after you have successfully
calibrated by running or walking.
If you want to calibrate the device immediately after pairing,
go directly to step 4. Otherwise, start from the beginning.

CALIBRATE BY RUNNING OR WALKING

1. Press MODE repeatedly to select
2. Press SET.
3. Press ST/LAP/+ repeatedly to select "CAL DEVICE".
4. Press SET.
5. Press ST/LAP/+ to select "CAL BY RUN" or "CAL BY
WALK".
6. Press SET to confirm selection.
7. The watch will conduct a device search first, as
indicated by flashing
flashing, then press SET to start calibration.
8. Ensure to complete walking or running the selected
.
and . Wait until stops
distance for calibration.
Ø If calibration is successful, the watch will display
Run parameter
NOTE
The Run parameter and Walk parameter is the
value to enter when calibrating by inputting parameter.
Ø If calibration fails, the watch will display
NOTE
The SZ909 chest belt should be calibrated both
by running and walking.
11
or
Walk parameter