Start.a.workout; Take.a.lap.or.split - Timex Ironman Global Trainer Bodylink Guia Do Usuário

PWR-PEAK
PACER
SPEED
SPD-AVG
SPD-INZN
SPD-MAX
TIME-LAP
TIME-LEFT
TIME-STOP
TIME-SPLT
TIME-SGMT
TIME-EVT
TIME DAY
TIMER-1
TIMER-2
TIMER-3
TIMER-4
TIMER-5
Start a Workout
1. Press MODE until PERFORMANCE appears.
2. Press  or q to select a view screen.
3. Press START/SPLIT to start the chronograph and begin your workout.
NOTE: If the GPS is not fixed on a satellite, this message displays:
If you select NO, the chronograph will not start. Move into a position with a clear view of the sky where the
Global Trainer watch can receive and fix onto the GPS signals.
™
NOTE: The first time you wear the Global Trainer
subsequent sessions, the GPS signal fix should take 30 to 90 seconds. If a subsequent session takes longer
than 2 minutes for GPS signal fix, this message displays:
If you select YES, the GPS signal fix will go into full search mode, which may take several minutes.
NOTE: The maximum time the chronograph will measure is 20 hours. If this time is reached, you must save or
reset the workout.
Take a Lap or Split
Press START/SPLIT when the chronograph is running to take a lap or split. Up to three displays will appear in
sequence.
NOTE: While the lap data is being displayed, the chrono has begun timing the next lap.
highest power in watts reached during this workout
amount of time ahead or behind selected target set in Performance Pacer
current speed
average speed over entire workout
amount of time spent in your defined speed zone
fastest speed reached during this workout
time for current lap
estimated time to reach the next waypoint
total rest time during workout
total time elapsed since beginning of workout
total time elapsed since the beginning of this activity as selected in Multisport Mode
total time of event including transition and rest periods
current time of day
custom timers which can be set to include multiple repetitions and intervals
watch, this GPS signal fix may take several minutes. For
™
7