Power Meter; Configure.power.meter.settings; Gps - Timex Ironman Global Trainer Bodylink Guia Do Usuário

You can also use the "roll-out" method to measure your wheel circumference.
1. P lace your front wheel on the ground with the valve stem in the 6 o'clock position.
2. Mark the position of the valve stem on the floor.
3. R oll the bike forward, keeping pressure on the handlebars, until the valve stem is again at the
6 o'clock position.
4. Mark the position of the valve stem on the floor.
5. Measure the distance between the two marks.

Power Meter

Set up how the Global Trainer
Configure Power Meter Settings
1. Press MODE until CONFIGURE displays.
2. Press q to highlight POWER METER, then press 8 .
3. P ress  or q to highlight the setting to change, then press 8 to open the setting change window.
4. P ress  or q to highlight a selection in the setting change window, then press 8 to confirm your
selection.
Setting Group
THRESHOLD
VIEW
ZONES
Minimum / Maximum
Values for ZONES 1-6

GPS

Configure options for the GPS, view device version information, and view satellites. You can also reset the
watch and update the firmware from this menu.
27 X 1 3/8
27 X 1 1/4
27 X 1 1/8
27 X 1
26 X 2.125
26 X 1.9
26 X 1.5
26 X 1.25
26 X 1.0
26 X 1/650 C
26 X 1 3/8
Bodylink System watch calculates and displays power meter zones.
™ ®
Enter the threshold power in watts. The range is 0 to 600.
Select watts or % of threshold.
Select USE THRESHOLD to automatically calculate values, or select CUSTOM to
enter ranges for the six zones.
Enter the minimum and maximum values for each custom zone. Press
the setting change window. The minimum is 1. All six CUSTOM zones must appear
in ascending order and their values cannot overlap. The acceptable range is
1 - 999 watts or 1 - 100%.
30
2169
2161
2155
2145
2070
2055
1985
1953
1913
1952
2068
Adjustment
8
to close