Turn.the.global.trainer ™ .Watch.on.and.off; Charge.your.global.trainer .Watch - Timex Ironman Global Trainer Bodylink Guia Do Usuário

Status Bar
The status bar appears at the bottom of all screens. It shows the battery charge remaining, the current time,
and status icons to give an at-a-glance view of the Global Trainer
Battery icon
Chrono icon
t
Alarm icon
d
Timer icon
H
2:00 PM Time of Day text
Heart icon
g
RPM icon
Power icon
Satellite icon
Charge Your Global Trainer
Before you use the Global Trainer
A depleted battery takes approximately 2 1/2 to 3 1/2 hours to fully charge.
CAUTION: The Global Trainer
(0°C - 45°C).
Charge Using the USB Cable
1. I nsert the large USB-A plug on the download/charging clip into a USB port on any powered computer.
2. A ttach the download/charging clip to the back of the Global Trainer
3. M ake sure the four contacts on the clip touch the four metal discs on the back of the watch. Match the
red dot on the watch with the red dot on the connector for proper orientation.
4. S ecure the clip to the watch caseback by placing the fixed end of the clip into the slot adjacent to the
red dot and locking the hinged end of the clip into the other slot.
Charge Using the AC Adaptor
1. I nsert large USB-A plug on the download/charging clip into the USB port on the AC adaptor, and plug the
AC adaptor into an electrical outlet.
2. A ttach the download/charging clip to the back of the Global Trainer
3 and 4.
The Power Off Function is set to SHOW TIME, so the date and time will display during charging. A blinking
battery icon appears during charging. A solid battery icon appears when charging is complete.
U se only the Phihong PSB05R-050Q power adaptor supplied with this product.
NOTE: To prevent corrosion, please dry the download/charging contacts and the surrounding area on the back
of the Global Trainer watch.
™
Turn the Global Trainer
To turn the Global Trainer watch on or off, press and hold 8 for 2 seconds until you hear a three-note tone.
™
The tone ascends in pitch when powering on, and descends in pitch when powering off.
Because the Power Off Function is set to SHOW TIME, the date and time will display when the Global Trainer
watch is turned off. The POWER OFF label will appear in the upper status bar.
When the Power Off Function is set to TURN OFF DISPLAY, better standby battery life is obtained. To learn
more about the Power Off Function, refer to the CONFIGURE (Mode) and the MODES sections of this USER
GUIDE.
NOTE: The display contrast can change due to temperature changes. To adjust the contrast level, follow
these steps.
Shows the approximate charge of the battery. More dark
segments indicates a higher charge. The icon shows the charge
remaining while charging, plus the remaining section to charge
blinks.
Appears when the chronograph is running.
Appears when the alarm is set.
Appears when the chrono is running and a timer has been
enabled.
Current time
Solid: Heart rate monitor is communicating properly.
B linking: Device is pairing or has received no useful data for
15 seconds.
Solid: Bike speed or cadence sensor is communicating properly.
Blinking: Device is pairing or has received no useful data for
15 seconds.
Solid: Power meter is communicating properly.
Blinking: Device is pairing or has received no useful data for
15 seconds.
Solid: GPS has a satellite fix.
Blinking: GPS is seeking a satellite fix.
None: GPS cannot locate a satellite.
Watch
™
watch for the first time, the lithium-ion battery must be charged.
™
watch should only be charged within a temperature range of 32°F - 113°F
™
Watch On and Off
™
watch's status.
™
watch.
™
watch, as instructed above in steps
™
3
™