Configure.units.settings; Modes; Configure.mode.settings; Pc Sync Mode - Timex Ironman Global Trainer Bodylink Guia Do Usuário

Configure Units Settings
1. Press MODE until CONFIGURE displays.
2. Press q to highlight UNITS, then press 8 .
3. P ress  or q to highlight the setting to change, then press 8 to open the setting change window.
4. P ress  or q to highlight a selection in the setting change window, then press 8 to confirm your
selection.
Setting Group
GLOBAL
DISTANCE UNITS
SPEED UNITS
PACE UNITS
ALTITUDE UNITS
ASCENT UNITS
All measurement data in Performance, Multisport, or Review modes will be expressed using the units you
selected.

Modes

Activate or deactivate Navigate Mode and associated functions, and configure power off behavior.
Configure Mode Settings
1. Press MODE until CONFIGURE displays.
2. Press q to highlight MODES, then press 8 .
3. P ress  or q to highlight the setting to change, then press 8 to open the setting change window.
4. P ress  or q to highlight a selection in the setting change window, then press 8 to confirm your
selection.
Setting Group
NAVIGATE MODE
POWER OFF
FUNCTION

PC Sync Mode

Use PC Sync Mode to make setting changes to the Global Trainer
computer. All Global Trainer
watch. You can also upload workout data from the Global Trainer
tracking, and use this data with your Timex Trainer powered by TrainingPeaks account to optimize your
workout program.
Select ENGLISH, METRIC, or NAUTICAL. This globally changes all units listed below.
Units for specific measurements can be changed individually, but changing the global
setting overrides all specific changes to individual units mentioned below.
Select miles to report distance in miles, km to report in kilometers, or nm to report in
nautical miles.
Select mph to report speeds in miles per hour, kpm to report in kilometers per hour, or
kn to report in knots.
Select min/mi to report pace in minutes per mile, min/km to report in minutes per
kilometer, or min/nm to report in minutes per nautical mile.
Select ft to report altitude in feet, or m to report in meters.
Select ft/min to report ascent/descent in feet per minute
meters per minute.
Select ENABLE to make Navigate mode and the Track Back feature available, or select
DISABLE to turn off these features.
Select SHOW TIME to display the date and time when the Global Trainer
powered off, or select TURN OFF DISPLAY to make the display blank.
watch settings can be changed from the device agent and downloaded to the
™
Adjustment
or m/min to report ascent in
,
Adjustment
Bodylink System watch from your
™ ®
watch to your computer for long-term
™
33
watch is
™