BMW Motorrad R 1250 RT 2020 Manual De Instrucciones página 378

Le présent appareil est conforme
aux CNR d'Industrie Canada
applicables aux appareils radio
exempts de licence.
L'exploitation est autorisée aux
deux conditions suivantes :
(1) l'appareil ne doit pas produire
de brouillage, et
(2) l'utilisateur de l'appareil doit
accepter tout brouillage
radioélectrique subi, même si le
brouillage est susceptible d'en
compromettre le fonctionnement.
FCC ID: QZ9-XXX
IC: 5927A-XXX
NOTICE:
Changes or modifications made
to this equipment not expressly
approved by Bury Sp. z o.o. may
void the FCC authorization to
operate this equipment.
NOTE:
This equipment has been tested
and found to comply with the
limits for a Class B digital
device, pursuant to Part 15 and
to Part 18 of the FCC Rules.
These limits are designed to
provide reasonable protection
against harmful interference in a
residential installation. This
equipment generates, uses and
can radiate radio frequency
energy and, if not installed and
used in accordance with the
instructions, may cause harmful
interference to radio
communications.
This equipment generates, uses
and can radiate radio frequency
energy and, if not installed and
used in accordance with the
instructions, may cause harmful
interference to radio
communications. However,
there is no guarantee that
interference will not occur in a
particular installation. If this
equipment does cause harmful
interference to radio or
television reception, which can
be determined by turning the
equipment off and on, the user
is encouraged to try to correct
the interference by one or more
of the following measures:
• Reorient or relocate the
receiving antenna.
• Increase the separation
between the equipment and
receiver.
• Connect the equipment into an
outlet on a circuit different from
that to which the receiver is
connected.
• Consult the dealer or an
experienced radio/TV technician
for help.
Radiation Exposure:
This device has been tested for
human exposure limits and
found compliant at a minimum
distance of 5 cm during
operation. Thus during the
operation of device a distance
of 5 cm must be respected in
every direction.