Aventics PROFINET IO Manual Del Usuario página 82

82 AVENTICS | Bus Coupler AES/Valve Driver AV, PROFINET IO | R412018140–BAL–001–AG
PLC Configuration of the Valve System
Table 11: Manufacturer-specific diagnosis
User Structure Identifier (USI), 16 bits
1)
1-42 Module number
63 Bus coupler
64 Configuration error
2)
65-106 Module configuration information
1)
1 = module 1, 2 = module 2, 3 = module 3, ...
2)
65 (0x41) = module 1, 66 (0x42) = module 2, 67 (0x43) = module 3, ...
Example:
64 Group diagnosis
1 Actuator voltage UA < 21.6 V (UA-ON)
2 Actuator voltage UA < UA-OFF
3 Electronics power supply UL < 18 V
4 Electronics power supply UL < 10 V
5 Hardware error
9 The backplane of the valve zone outputs a warning.
10 The backplane of the valve zone outputs an error.
11 The backplane of the valve zone attempts a re-initialization.
13 The backplane of the I/O zone outputs a warning.
14 The backplane of the I/O zone outputs an error.
15 The backplane of the I/O zone attempts a re-initialization.
64 The configuration for the master does not match the configuration for the slave.
1 The connected module is not configured.
2 The configured module is not available.
3 A module different than the configured one has been connected.
Module 5 has an error.
Table 12:
User Structure Identifier (USI)
5
The power supply for the electronics has fallen below 18 V.
Table 13:
User Structure Identifier (USI)
63
If both errors occur at the same time, two error telegrams will be sent.
Table 14:
Telegram number
1st telegram
2nd telegram
If both the electronics and the actuator voltage fall below 18 V or 21.6 V, two error telegrams will be
sent.
Table 15:
Telegram number
1st telegram
2nd telegram
Diagnostic data (data), 16 bits
User Structure Identifier (USI)
5
63
User Structure Identifier (USI)
63
63
Diagnostic data (data)
64
Diagnostic data (data)
3
Diagnostic data (data)
64
3
Diagnostic data (data)
3
1