Rating Plate On Bus Coupler; Plc Configuration Key; Plc Configuration Key For The Valve Zone - Aventics PROFINET IO Manual Del Usuario

AVENTICS | Bus Coupler AES/Valve Driver AV, PROFINET IO | R412018140–BAL–001–AG
12.3.5

Rating plate on bus coupler

The rating plate is located on the back of the bus coupler. It contains the following information:
47
48
49
50
51
52
53
54
55
Fig. 15: Bus coupler rating plate
47 Logo
48 Series
49 Mat. no.
50 MAC address
51 Power supply
52 Manufacture date (FD) with format "FD:
<YY>W<WW>"

12.4 PLC configuration key

12.4.1

PLC configuration key for the valve zone

The PLC configuration key for the valve zone (59) is printed on the right end plate.
The PLC configuration key specifies the sequence and type of electrical components based
on a numerical/alphabetical code. The PLC configuration key consists solely of numbers, letters,
and dashes. There are no spaces between the values.
In general:
Numbers and letters refer to the electrical components.
Each digit corresponds to one valve driver board. The number's value refers to the number
of valve positions for a valve driver board.
59
Letters refer to special modules that are relevant to the PLC configuration.
"–" visualizes a pneumatic supply plate without UA-OFF monitoring board; not relevant
to the PLC configuration
The sequence begins on the right side of the bus coupler and ends at the right end of the valve
system.
The elements that can be represented in a PLC configuration key are shown in Table 25.
Conversion of the Valve System
58 57
53 Serial number
54 Manufacturer's address
55 Country of manufacture
56 Data Matrix code
57 CE mark
58 Internal plant ID
103
56