Control Panel - Honda Motor EU65is Manual De Instrucciones

cap.06 EU65is 6500is (Eu).qxd 07.12.17 4:51 PM ページ6-5

3. CONTROL PANEL

a. REMOVAL/INSTALLATION
1) Remove the following:
– Handle (P. 16-1).
– Battery (P. 5-1).
– Front cover (P. 6-1).
– Inverter unit (P. 6-2).
2) Turn the fuel valve lever to the OFF position.
3) Remove the 4 mm screw and fuel valve lever.
4) Installation is the reverse order of the removal. Note the
following.
5) Install the fuel valve lever, and tighten the 4 mm screw to
the specified torque.
TORQUE: 2.1 N . m (0.2 kgf . m, 1.5 Ibf . ft)
[14]
FUSE BOX
[13]
1A FUSE (3)
6-5
[2] RIGHT HANDLE BRACKET
INSTALLATION:
Loosely install the 8 mm
flange nuts, then pull the
bracket up and tighten the 8
[1] CONTROL PANEL
mm flange nuts securely.
DISASSEMBLY: P. 6-6
through 10
REASSEMBLY: P. 6-12
through 17
[11]
15A FUSE
[9]
"L" MARK
[10]
WIRE HARNESS
BAND (2)
[12]
FUSE COVER
[1]
FUEL VALVE
LEVER
[2] 4 mm SCREW
[3]
"R" MARK
[4]
8 mm FLANGE
NUT (4)
[5]
5 x 8 mm PAN-HEAD
SCREW
[6] GND3
INSTALLATION:
P. 2-60
[7]
6 mm FLANGE NUT (3)
8.5 N . m (0.9 kgf . m,
6.3 lbf . ft)
[8]
LEFT HANDLE BRACKET
INSTALLATION:
Loosely install the 8 mm flange
nuts, then pull the bracket up
and tighten the 8 mm flange
nuts securely.