Self-Diagnostic Function - Honda Motor EU65is Manual De Instrucciones

cap.02 EU65is 6500is (Eu).qxd 07.12.17 4:25 PM ページ2-9
9. TROUBLESHOOTING

SELF-DIAGNOSTIC FUNCTION

The generator control unit (GCU) has a self-diagnosis function.
When it detects a fault, it notifies the operator by flashing an
error code and turning on or flashing the overload indicator.
When an error code appears on the i-Monitor, troubleshoot
using the failure by error code table (See P. 2-11).
HOW TO DISPLAY THE ERROR LOG
NORMAL DISPLAY MODE
When you turn the ignition switch to the ON position, the i-
Monitor displays the engine run-time. Every time you press the
display button, the display will show the generator output, the
engine speed, and the battery voltage in this sequence.
ERROR LOG MODE
When you press the display button longer than 3 seconds, the
i-Monitor goes into the error log mode, displaying error codes
for previous incidents. Every time you press the display button,
the display will show the five latest error codes in the order
from the newest to the oldest. When END appears in this
mode, press the display button longer than 3 seconds to
change the display back to the normal display mode.
DETAILED ERROR LOG MODE
When you press the display button longer than 3 seconds on
an error code, the display goes into detailed error log mode,
and it shows the engine run-time, generator output, engine
speed, inverter temperature, throttle angle, and battery voltage
for the incident in this sequence. When END appears in this
mode, press the display button longer than 3 seconds to
change the display back to the error log mode.
2-9
OVERLOAD
OUTPUT
INDICATOR
INDICATOR
i-MONITOR
DISPLAY BUTTON
NORMAL DISPLAY MODE
Engine run time (hour)
Generator output (VA)
Engine speed (rpm)
Battery voltage (V)
ERROR LOG MODE
Error log 1 Error code
Error log 2 Error code
Error log 3 Error code
Error log 4 Error code
Error log 5 Error code
end
DETAILED ERROR LOG MODE
Error detail 0
Error detail 1
Error detail 2
Error detail 9
Error detail a
Error detail b
end
OIL ALERT ®
INDICATOR
Error code: P. 2-11
Error detail
description: P. 2-10