Honda Motor EU65is Manual De Instrucciones página 416

cap.14 EU65is 6500is 07.12.17 5:05 PM ページ14-9
• CONNECTING ROD BIG END SIDE CLEARANCE
Standard
0.1 – 0.7 mm
(0.004 – 0.028 in)
• CONNECTING ROD BIG END OIL CLEARANCE
1) Clean the oil from the crankpin and connecting rod big end
surface.
2) Place a piece of plastigauge on the crankpin, install the
connecting rod and cap, and tighten the bolt to the
specified torque.
TORQUE: 14 N . m (1.4 kgf . m, 10 Ibf . ft)
• Do not rotate the crankshaft while the plastigauge is in
place.
3) Remove the connecting rod and measure the plastigauge.
Standard
0.040 – 0.066 mm
(0.0016 – 0.0026 in)
4) If the clearance exceeds the service limit, replace the
connecting rod and recheck the clearance.
• CAMSHAFT
Inspect for worn and weakened springs and check that the
decompressor weight moves smoothly.
<CAMSHAFT O.D.>
Standard
15.966 – 15.984 mm
(0.6286 – 0.6293 in)
14-9
Service limit
1.0 mm
(0.04 in)
Service limit
0.12 mm
(0.005 in)
Service limit
15.920 mm (0.6268 in)
[1]
PLASTIGAUGE
[1]
DECOMPRESSOR
WEIGHT