Display Indications; Drive Status Indications; The Diagnostics Menu - Parker 650 Serie Manual De Producto

5-2
The Keypad

Display Indications

Drive Status Indications

The DIAGNOSTICS Menu

g
when in the Parameter menu
when in the Setup menu
when displaying an Alarm code
a negative parameter value
Indicates the
rive is running in
Control Mode
perating mode.
de if not visible.
Represents a rotating shaft:
clockwise = drive running forward
anticlockwise = drive running in reverse
Indicates parameter numbers or values,
trip information, error codes etc.
See "Drive Status Indications" below.
The keypad can display the following status information:
Display Status Indication and Meaning
READY/HEALTHY No alarms
present. Remote mode selected
PASSWORD Current password
must be entered before this
parameter may be altered.
LOCAL Local Control selected,
healthy, no alarms present
RUN Not possible to change
between Local/Remote mode
JOG Not possible to change
between Local/Remote mode
Display Name
FREQUENCY
SPEED SETPOINT
DC LINK VOLTS
MOTOR CURRENT
Displays the units for the value:
S
for time in seconds,
V
for voltage in Volts,
Hz
for frequency in Hertz
Indicates the drive is in Local control.
Drive is in remote control when not visible.
Possible Cause
Enter password to change the
parameter. Refer to page 5.5
Added or removed from the
display letter-by-letter to indicate
entering or leaving Local Control
The drive is running in Local
mode or the Remote run signal is
active
The Remote jog signal is active
Description
The current output frequency in Hertz
The set point as a percentage of MAX SPEED
Vac (rms) x 2 = dc link Volts
(when motor stopped)
The current load value in Amps
A
for current in Amps
%
for percentage
Indicates control
via fieldbus
communications
650 Series AC Drive