The Default Application; How To Load An Application; Application Description - Parker 650 Serie Manual De Producto

A
PPLICATIONS
1 2

The Default Application

DEFAULT
IMPORTANT: Refer to Chapter 5: The Keypad – Special Menu Features to reset the drive to factory

How to Load an Application

Application Description

Control Wiring for Applications
Key to Application Diagrams
The drive is supplied with 6 Applications, Application 0 to Application 5. Each Application
recalls a pre-programmed structure of internal links when it is loaded.
 Application 0 will not control a motor. Loading Application 0 removes all internal links.
 Application 1 is the factory default application, providing for basic speed control
 Application 2 supplies speed control using a manual or auto setpoint
 Application 3 supplies speed control using preset speeds
 Application 4 is a set-up providing speed control with Raise/Lower Trim
 Application 5 supplies speed control with Run Forward/Run Reverse
default values which are suitable for most applications.
In the menu, go to
The Applications are stored in this menu.
Use the keys to select the appropriate Application by number.
Press the key to load the Application.
The large Application Diagrams on the following pages show the full wiring for push-button
starting. The diagrams on the reverse show the full wiring for single wire starting.
For the minimum connections to make the drive run refer to Chapter 3: "Installing the Drive" -
Electrical Installation; the remaining connections can be made to suit your system.
When you load an Application, the input and output parameters shown in these diagrams default
to the settings shown. For alternative user-settings refer to the Software Product Manual,
Chapter 1 "Programming Your Application".
normally open contact (relay)
2-position switch
and press the key twice.
Applications
normally open push-button
normally closed push-button
650 Series AC Drive
12-1