SKF Lincoln Guía De Instalación Y Mantenimiento página 8

Refer to Service parts list, page 4 for parts identification.
Bench test/operation
Fig. 5
Do not exceed the lowest pressure rating
of any component in the system.
6
7
condition. Replace any suspect parts
prior to operation.
8
the system, disconnect air to the motor.
9
Personal injury can occur.
10 Starting pressure
1 Set air pressure at the regulator to zero.
2 Screw connector (2) [with thread sealant]
into the inlet of the air motor assembly.
Tighten the connector securely.
3 Install air coupler (3) onto the air supply
line.
11
4 Connect the air coupler assembly to the
connector.
12
13
sure reaches 30 psi (2,1 bar).
to Troubleshooting, pg 10 for details.
4
5
5 Supply air pressure not to exceed 30 psi
(2,1 bar) to pump motor.
14
15
16
11
17
11
18
19
8
W A R N I N G
Ensure all components are in operable
Should leakage occur anywhere within
!
Notice
Pump must cycle once air pres-
If pump assembly does not cycle refer