Replacing The Light Bulb; "Cleaning" Function; Pyrolytic Self-Cleaning; Pyrolysis - De Dietrich DOR7586A Guía De Utilización

5
•
CARE

REPLACING THE LIGHT BULB

Warning
Make sure the appliance is
disconnected from the power before
replacing the bulb in order to avoid
the risk of electric shock. Carry out
the operation when the appliance has
cooled.
Bulb specification:
25 W, 220-240 V~, 300°C, G9.
You can replace the bulb yourself.
Unscrew the view port and remove the
bulb (use a rubber glove, which will
make it easier to remove). Insert the
new bulb and replace the view port.

"CLEANING" FUNCTION

(the cavity)
Remove the accessories and
supports from the oven before
beginning pyrolysis cleaning. Before
starting a pyrolysis cleaning cycle,
make sure that any accessories that
are not pyrolysis safe have been
removed from the oven (sliding rails,
baking trays, chrome-plated grills,
and so on) as well as any cookware.

PYROLYTIC SELF-CLEANING

This oven is equipped with a pyrolytic
self-cleaning function:
Pyrolysis is a cycle during which the
oven cavity is heated to a very high
temperature in order to eliminate soiling
from splattering and spills.
Before starting pyrolysis cleaning,
remove any large overspills, if any.
Remove the excess grease on the door
using a damp sponge.
As a safety measure, cleaning only
occurs after the door locks automatically;
it is impossible to unlock the door.
PERFORM A SELF-CLEANING
CYCLE
Three pyrolysis cycles are proposed.
The durations are pre-selected and
cannot be modified:
Express Pyro: in 59 minutes
This specific function uses the heat
built up during a previous cooking
29