Tabla De Contenido; Symbols Used In This Document; General Information - Grundfos TP Serie Instrucciones De Instalación Y Funcionamiento

English (GB) Installation and operating instructions
Original installation and operating instructions
CONTENTS
1. Symbols used in this document
2. General information
3. Delivery and handling
3.1 Delivery
3.2 Handling
4. Applications
4.1 Pumped liquids
5. Installation
5.1 Pipework
5.2 Elimination of noise and vibrations
5.3 Foundation
5.4 Terminal box positions
5.5 Base plate
5.6 Insulation
5.7 Frost protection
6. Electrical connection
6.1 Frequency converter operation
7. Startup
7.1 Flushing the pipe system
7.2 Priming
7.3 Checking the direction of rotation
7.4 Starting
7.5 Shaft seal run-in
7.6 Frequency of starts and stops
8. Maintenance and service
8.1 Pump
8.2 Motor
8.3 Service
8.4 Adjusting the shaft
8.5 Blanking flanges
9. Technical data
9.1 Ambient temperature
9.2 Liquid temperature
9.3 Operating pressure/test pressure
9.4 Inlet pressure
9.5 Enclosure class
9.6 Electrical data
9.7 Sound pressure level
9.8 Environment
10. Fault finding the product
11. Disposal
Warning
Prior to installation, read these installation
and operating instructions. Installation and
Page
operation must comply with local
regulations and accepted codes of good
5
practice.
5
6

1. Symbols used in this document

6
6
Warning
7
If these safety instructions are not
7 observed, it may result in personal injury.
7
If these safety instructions are not
9
Caution observed, it may result in malfunction or
9
damage to the equipment.
10
11
Notes or instructions that make the job
Note
11
easier and ensure safe operation.
11
11

2. General information

12
These instructions apply to the pump types TP and
12
TPD fitted with Grundfos motors. If the pump is fitted
with another motor make, please note that the motor
13
data may differ from the data stated in these
13
instructions.
13
13
14
14
14
14
14
15
15
15
16
16
16
16
16
16
16
16
16
16
17
18
5