Troubleshooting - Brill 36 EH Manual Del Usuario

Note:
In order to ensure a good
filling result, you should clean
the grass collecting sack
GB
and especially the air grid
after use.
Hanging the grass collecting
bag in
Warning! Only hang the
A
grass collecting bag in
when the motor has been
9. Maintenance, Care and Storage
Maintenance
Maintenance covers all work
that keeps your lawnmower in
good working order. You can
prevent accidents and failure of
parts by checking your lawn-
mower regularly (check that the
bolted connections are secure,
check for cracks and damage)
and by replacing damaged or
worn parts.
Repairs must only be carried
out by the service centres
authorised by the manufacturer
or authorised specialist dealers.
Warning! Disconnect the
A
mains plug before carrying
out all maintenance work!
Otherwise there is a risk of injury.
Check the grass catching device
regularly for wear or reduced func-
tion. For safety reasons, always
replace worn or damaged parts.
Never clean your lawnmower
under running water and in par-

10. Troubleshooting

General
Faults usually occur if the
unit has not been handled,
22
switched off and the cutting tool
is at a standstill.
Lift the protective flap on the
lawnmower with one hand.
Hold onto the carrying handle
of the grass collecting bag
with the other hand, Hang it into
the latching device.
Note:
If it has been hung in correctly,
the protective flap is exactly
ticular never using a highpres-
sure water jet due to the danger
of injury to people and property.
Store your lawnmower in a dry
place that is protected from frost.
Store your lawnmower out of the
reach of children.
Follow the instructions for instal-
lation when replacing the blades.
Exchanging the Blade
Please only use original replace-
ments blades supplied by the
manufacturer. Original replace-
ment blades are available from
your specialist dealer.
Never use replacement parts or
accessories not supplied by the
manufacturer.
If the cutter bar is damaged, it
must be replaced due to the
associated problems with imbal-
ance. For safety reasons, the cut-
ter bar must only be replaced at
the service centres approved by
cared for or maintained prop-
erly. The following table
contains the most common
faults and remedies to eliminate
positioned on the grass collect-
ing bag.
Mowing without using the
grass collecting bag.
The protective flap is so posi-
tioned that it is possible to mow
without the grass collecting bag
and with the protective flap
closed. In this case, the cuttings
are deposited on the lawn
underneath the protective flap.
the manufacturer or by specialist
dealers.
Do not regrind the cutter bar
(out of balance).
To replace the cutter bar, loosen
both of the screws (fig. H, item 2).
When inserting it, ensure that
the wings of the cutter bar
(fig. H, item 1) point in the direc-
tion of the housing, Insert both of
the screws (fig. H, item 2) and
tighten them. (Torque: 8 Nm).
Care
The easiest way to remove dirt
and grass cuttings is directly
after mowing. Clean your lawn-
mower with a brush and cloth.
Wear suitable work gloves.
Storage
Always store your lawnmower
indoors.
Warning! When folding
A
together ensure that the
cable is not bent or trapped.
these faults. If you have any
other problems, please contact
your nearest service centre
authorised by the manufacturer,