Brill 36 EH Manual Del Usuario página 23

or your nearest authorised
specialist dealer.
Caution! Repairs that
A
require specialist
knowledge must only be carried
out by an authorised specialist.
Caution! For safety reasons,
A
only use original spare
Fault
Abnormal noises,
lawnmower rattles.
Whistling noise.
Lawnmower does not run
smoothly or vibrates vigorously.
Aerator roller is not operating
with the blade.
Lawn turning yellow,
cut not clean.
Mower leaves deep tracks.
Motor not running.
11. Instructions for correct use, safety instructions
Check each time you use
A
the equipment
Inspect the equipment each time
before you use it. Do not use
the equipment if safety devices
(switch handle, safety covers)
and / or if the cutting device is
damaged or worn. Never dis-
able safety devices.
Always carry out a visual
inspection before use in order
to determine whether the cutting
parts supplied by the manufac-
turer or parts that have been
authorised by the manufacturer.
We expressly point out that in
accordance with product liability
laws, we are not liable for any
damage caused by our units if
this damage is due to improper
repair or if parts exchanged
Possible Cause
Bolts at motor, its fixings or
mower housing are loose.
Foreign body blocking
aerator roller.
V-belt slipping.
Blade or blade flange damaged
(unbalanced), screw loose.
Blade flange loose on the motor
shaft.
Rotary switch at 0 position.
V-belt torn.
Blade is too blunt,
cutting height too low.
Ground softened by water,
lawn too wet.
No power supply.
tool is worn or damaged and
that no screws are loose.
Check the work area before
starting work. Remove any for-
eign bodies present (e. g. stones,
branches or bones). Check for
foreign bodies whilst working.
Always wear sturdy footwear
and long trousers when working
with the appliance. Do not use it
when barefooted or only wear-
ing light sandals.
are not our original parts or
parts approved by us, and if
the repairs were not carried
out at service centre authorised
by the manufacturer or by an
authorised specialist. The same
applies to spare parts and
accessories.
Remedy
Tighten bolts.
Switch off aerator roller,
remove foreign body.
Contact specialist workshop /
service centre.
Retighten the screws.
Have damaged parts replaced
by the service station.
Turn rotary switch to 1 with the
motor switched off.
V-belt must be replaced by
specialist workshop.
Change blade and / or use
a slightly higher cutting height.
Allow lawn to dry,
do not mow if grass is wet.
Check power is available.
Check the cutting tools regularly
for damage and have them
repaired correctly if necessary.
Only have cutting tools
replaced by Brill Service or your
authorised specialist dealer.
Use /
A
Responsibility
Caution! The safety devices
A
installed on the appliance
by the manufacturer are neither
GB
23