La Crosse Technology A92239 Manual Del Usuario página 35

6.0 Chronography Mode - Start/Stop the Chronograph
Minutes Seconds
Chronograph Mode
'All Zero' Display
Chronograph Mode
'Counting' Display
Hold
Chronograph Mode
[R]
'Stop' Display
6.1 Chronography Mode - Recording and Recalling Lap Time
Stop Co u n tin g
Disp lay
Co u n tin g
Disp lay
To Record Lap Time
Total Time
Display
Lap Times Recall Sequence
NOTE*: Press [R] to move selection in the reverse direction
1/100 Seconds
Digits
running
Digits
Stop
Counting
Elapsed
Time
the lap no. will flash and
lap time will freeze
10
sec
L ap Disp lay
hold [M]
the 1st
record
the 2nd.
record
the last
record
24
Chronograph Mode
● The Station includes Chronograph function to measure
elapsed time, accumulative elapsed time and lap time.
● The display shows the 'All Zeros' display when the
chronograph is selected for the first time or the
chronograph is reset.
How to Measure Elapsed Time
● When the chronograph is stopped (not counting), press
[S/S] once to start the chronograph (counting); press
[S/S] once again to stop the chronograph (not counting).
● The elapsed time from the first to the second [S/S]
keystroke will appear on the display.
● Repeat the above steps to get the accumulative elapsed
time in which the chronograph is counting.
How to Reset the Chronograph
● Hold [R] for 2 seconds to reset the chronograph to 'All
Zeros' display when the chronograph has been
stopped.
● On 'All Zeros' display, the chronograph is ready for a
new counting.
NOTE:
- When the user resets the chronograph, the lap time
records will be reset at the same time.
- When time is over an hour, it will show hour, minute and
second digits. ( Example: One hour shows as 1:00 00 )
Lap Time
● The chronograph can measure lap time without stopping
counting.
● The Chronograph can record up to 10 lap time records.
How to Record Lap Time
● Press [R] once to record a lap time when the
chronograph is counting.
● The lap number will flash and lap time will freeze on the
display for 10 seconds, and it will return to counting
display automatically.
● Press [R] again at any designated moment to get another
lap time (the lap number increases by one). When you
stop the Chronograph, the total elapsed time will be
shown.
How to Recall Lap Times
● Hold [M] at this stage in the Chronograph Mode to recall
the lap time records. The first lap Time will be shown and
the icon "LAP" will flash.
● When the first lap Time Display is shown, press [S/S] or
[R] to check the lap time records. "LAP" is the total
elapsed time.
● Press [A/B] at any time to go back to the previous
chronograph display.
● When no key is pressed for 1 minute, it will return to the
previous chronograph display.
How to Reset Lap times
● Hold [R] for 2 seconds to reset the chronograph to 'All
Zeros' display when the chronograph has been stopped
counting.