Abicor Binzel iCAT Instructivo De Servicio página 37

iCAT WH
iCAT-WK adapter
1
Cylinder head screw M4x10
2
Dismounting the cable assembly
Fig. 9
1
5 4
Insulating sleeve top/bottom
3
Control lead
4
1 Disconnect the torch neck and remove it.
2 Disconnect the cable assembly from the wire feeder.
3 Unscrew cylinder head screw from corrugated hose clamp.
4 Unscrew cylinder head screw (2) from insulating sleeve (3).
(max. tightening torque 3 Nm)
5 Remove the insulating sleeves (3).
6 Disconnect control lead (4) from cable assembly to the iCAT
7 Unscrew the cylinder head screws (5) from the iCAT-WK adapter (1) to the
iCAT (max. tightening torque 3.5 Nm)
8 Remove iCAT-WK adapter (1) from the iCAT
9 Slide/pull cable assembly through the iCAT
Mount again in reverse order
6 Putting into operation
2 3
3
Cylinder head screw M4x10
5
EN - 15