Abicor Binzel iCAT Instructivo De Servicio página 44

12 Disposal
12 Disposal
12.1 Materials
12.2 Consumables
12.3 Packaging
EN - 22
NOTE
• Observe the information given in section 8 Putting out of operation on
page EN-18.
1 Dismounting the cable assembly
 see 6.4 Replacing the cable assembly on page EN-14
2 Dismount the iCAT WH from the robot.
 see 6.3 Fastening the iCAT WH and cable assembly to the robot on
page EN-11
For disposal, observe the local regulations, laws, provisions, standards and
guidelines. For the product to be properly disposed of, it first must be
dismounted.
 See 11 Dismounting on page EN-21
This product is mainly made of metallic materials which can be melted in steel
and iron works and are, thus, almost infinitely recyclable. The plastic materials
used are marked in preparation for sorting and separation of the materials for
later recycling.
Oil, grease and cleaning agents must not contaminate the ground or enter
sewage systems. These materials must be stored, transported and disposed of
in suitable containers. Observe the relevant local regulations and disposal
instructions of the safety data sheets specified by the manufacturer of the
consumables. Contaminated cleaning tools (brushes, rags, etc.) must also be
disposed of in accordance with the information provided by the manufacturer
of the consumables.
ABICOR BINZEL has reduced the packaging for shipping to a minimum.
Packaging materials are always selected with regard to their possible recycling
ability.
iCAT WH