Putting Out Of Operation; Maintenance And Cleaning; Electric Shock - Abicor Binzel iCAT Instructivo De Servicio

8 Putting out of operation

8 Putting out of operation

9 Maintenance and cleaning

EN - 18
Putting out of operation depends on the respective welding torch.
Please observe the operating instructions of the respective ROBO WH
welding torches.
Scheduled maintenance and cleaning is a prerequisite for a long life and a
trouble-free operation.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power source.
• Close off the compressed air supply.
• Pull the mains plug.
DANGER

Electric shock

Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation.
• Replace any damaged, deformed or worn parts.
NOTE
• The maintenance intervals given are standard values and refer to single-
shift operation.
• Maintenance and cleaning work may only be carried out by qualified
and trained specialists.
• Always wear your personal protective clothing when performing
maintenance and cleaning work.
• When replacing the liquid-cooled ROBO WH cable assemblies, make
sure that any coolant residues are removed from the iCAT ROBO WH
by blowing compressed air through it.
iCAT WH