Service Programs; Calling The Service Programs; System Information - Storz AUTOCON II 400 Manual De Servicio

4.5 Service programs

Caution: Make a note of the current password and make sure you don't lose it or forget

4.5.1 Calling the service programs

– Turn the device on.
– Go to "Device Setup: Select Option".
– Go to the "Service Programs" menu.
– Enter the password. The service password when the device leaves the manufacturers is "Tuttlingen".
– Press "Enter"
The "Service Programs" menu will be opened.

4.5.2 System information

– Open the "Service Programs" menu as described in Chapter 4.5.1 Calling the service programs.
– Press the "System Information" button.
– Press "Enter" to confirm the input.
The last 200 times that the device was activated are stored in System Information. They are shown in the
following order: Sequence number – Date – Time – Duration [s] – Socket – Effect – Power – Mode.
12.06 / V1.0
it. If you should change the password but then forget it, you will no longer be
able to set parameters or make any changes in the service programs. In this
case you should contact the service technician.
to confirm the password.
Figure 4.14
AUTOCON ® II 400
MODEL 205352 20-1
4-15