Columbus McKinnon YLITP ATEX 500 Instrucciones De Servicio página 38

Yalelift ITG 10000 kg and 20000 kg Yalelift LHG 10000 kg
1. Measure the flange width of the beam.
2. Evenly distribute the spacer sleeves and spacer washers on both sides of the suspension
bolt accordingly. A clearance of 2 mm between the wheel flange and the beam flange must be
maintained (inner dimension = flange width + 4 mm).
3. After adjustment of the inner dimension, evenly distribute the remaining spacer sleeves and
spacer washers on the outside of the side plates on the suspension bolt. In each case, at least
3 spacer washers and 1 spacer sleeve must be mounted between the side plates and the
castle nut.
Tip: For easier assembly, tighten one side plate. Observe the required position of the drive
side. Only slide on the other side plate without tightening.
4. Then lift the entire unit onto the track beam and firmly tighten all castle nuts.
5. Secure all castle nuts with cotter pins.
ATTENTION: A trolley must never be used on a beam with a flange width that exceeds
the maximum adjustable width of the trolley (observe total clearance of 5 mm, depends
on model) or with a profile which does not correspond to the profile the trolley has
been designed for.
Shorten or extend the hand chain
Adjust the length of the hand chain so that the distance of the lower end to the floor is between
500 – 1000 mm.
NOTE: For safety reasons, hand chain links may only be used once.
• Look for the non-welded link of the hand chain, bend to open and discard it.
• Shorten or extend the chain to the required length.
ATTENTION: Always remove or add an even number of chain links.
• Use a new link to close the loose chain ends by bending it (for extending the hand chain, two
new chain links are required).
ATTENTION: Make sure that hand chains are not twisted while they are fitted.