Franke CM 65 M Instrucciones De Uso página 19

All manuals and user guides at all-guides.com
LEDs
– blinking: ready for setting or signalling end of function (together
B
with the ringer)
– lit: function running
Timer ( )
To set the timer, press the knob on the right once (the corresponding
LED begins to blink); then turn the knob on the left to move the hands
in order to set the timer duration. Press the right knob again to
confirm the setting; the corresponding LED changes from blinking to
steady. The hands will then return to their original position to indicate
the current time: when the set time is reached, the ringer sounds. This
sound can be stopped by pressing the right knob.
The timer does not control oven heating.
End of cooking ( )
To set the end of cooking time, press the right knob twice (the LED for the symbol begins to flash); then turn the
knob on the left to move the hands in order to set the end of cooking time.
The LED will blink for the next 10 seconds (for possible adjustments), after which the setting will be acquired and the
LED becomes steady.
The same effect is obtained by pressing the right knob twice during blinking.
At the end of cooking, oven heating will be deactivated and the ringer will sound for 1 minute; this sound can be stopped
by pressing the right knob.
N.B.: At the end of cooking, the oven remains at a temperature close to the previously set value for several minutes; it is
therefore wise to remove the food from inside so as to avoid overcooking it.
End of cooking ( ) with delayed start ( )
Delayed start of cooking can only be activated following the end of a cooking process; when set, pressing the right knob
confirms the "stop", and at the same time activates the blinking LED for the symbol . Turn the left knob to also set
the start of cooking time (naturally this will be before the end, therefore the hands can only be moved back). Confirm by
pressing the right knob again. The data can also be automatically acquired by allowing the blinking to continue for
10 seconds. The LEDs for symbols and remain lit and the oven will switch on at the set time, when only the
LED for the symbol will remain lit.
At the end of cooking, the ringer will sound for 1 minute; this sound can be stopped by pressing the right knob.
Setting the time of day ( )
To set the correct time, just press the right knob three times (the LED for the clock symbol starts blinking), then turn the
left knob. After setting the right time, press the right knob to confirm.
Electronic cooking programmer
It enables oven programming in the following modes:
B
• delayed start of cooking with set duration;
• immediate start of cooking with set duration;
• timer.
Setting the digital clock
When the appliance has been connected to the mains or after a power failure the
display will flash on: "0.00".
Press the + and – buttons together for a few seconds. The time of day can be
adjusted with the + and – buttons, while the dot between the hours and minutes
flashes. If the time setting mode is selected when an automatic programme is
active, the automatic programme is cancelled.
Possible time adjustments can be made by repeating the steps described above.
14