Removing The Cover Support Element; Removing The Front Cover - APRILIA SR 50 Uso Y Mantenimiento

2
1
REMOVING THE
COVER SUPPORT ELEMENT
Carefully read p. 39 (MAINTENANCE).
Position the vehicle on the centre stand,
see p. 38 (POSITIONING THE VEHICLE
ON THE STAND).
Rotate the handlebar completely, unscrew
and remove the screws (1).
Remove the cover support element (2).
NOTE
Upon reassembly, fit the tangs cor-
rectly in the appropriate seats.
use and maintenance SR 50
50
4
5
REMOVING THE
FRONT COVER
Carefully read p. 39 (MAINTENANCE).
Remove the cover support element (2),
see beside (REMOVING THE COVER
SUPPORT ELEMENT).
Rotate the handlebar completely, unscrew
and remove the screws (3).
CAUTION
Proceed with care.
Do not damage the tangs and/or their
seats.
Handle the plastic and painted compo-
nents with care and avoid scraping or
damaging them.
Remove the front cover (4), by pulling it
upwards.
3
6
6
NOTE
Upon reassembly, correctly insert
the lower tang (5) and successively the four
side tangs (6) in their seats.