Approved Combinations Of Cutting Tool, Deflector, Handle And Harness - Stihl FS 110 Manual De Instrucciones

English / USA
Approved Combinations of Cutting Tool, Deflector, Handle
and Harness
Cutting tools
1 STIHL Supercut 20-2
2 STIHL Autocut 21-2
3 STIHL Autocut 25-2
4 STIHL Trimcut 30-2
5 STIHL Polycut 20-3
6 STIHL FixCut 25-2
7 Grass cutting blade 230-4
8 Grass cutting blade 230-8
1)
9 Brush knife 250-3
10 Scratcher tooth circular
1)
saw blade 200
11 Chisel tooth circular
1)
saw blade 200
Deflectors
12 Deflector for mowing heads only
13 Deflector with
14 Skirt and blade for all mowing heads
(see "Mounting the deflector")
15 Deflector without skirt and blade
for all metal mowing tools
16 Limit stop for circular saw blades
Handles
17 Loop handle
18 Loop handle with
19 Barrier bar
20 Bike handle
1)
Not approved for FS 85 RX or
FS 110 X
18
Harnesses
21 Shoulder strap may be used
22 Shoulder strap must be used
23 Full harnesss may be used
24 Full harness must be used
Equipment
1)
The complete unit includes:
1)
– Cutting tool
– Deflector
– Handle
– Harness (bike handle unit only)
Select the correct combination from the
table according to the cutting tool you
intend to use. Read the table
horizontally from left to right. Other
combinations, e.g. reading the table
diagonally, are not permitted.
!
Warning!
To reduce the risk of injury from thrown
objects and blade contact, never
operate your unit without the proper
deflector for the cutting attachment
being used. To reduce the risk of injury
from loss of control
and / or contact with the cutting tool,
make sure your unit is equipped with a
proper handle and harness for the type
of cutting attachment being used.
!
Warning!
STIHL brushcutters with a loop handle
without barrier bar may be used only
with the above mentioned mowing head
with nylon line or plastic blades. Other
plastic or metal cutting tools, but not
circular saw blades, may be used only
on brushcutters with a bike handle or
loop handle with barrier bar in order to
reduce the risk of personal injury
through contact with the cutting tool. To
reduce the risk of serious injury to the
operator or bystanders by kickout, never
use a circular saw blade on a
brushcutter with a loop handle. Circular
saw blades may be used only on
brushcutters with a bike handle.
FS 110