Mowox RM 750 BTU-SN Manual De Instrucciones página 430

When finishing the layout to the foreside of the charging station, leave another 1-me-
ter extra wire and then cut it.
The 1-meter extra wire serves for later corrections and has got
to be cut off when the installation is successful and all positions
At the end of the scheduled working time or
age is low, the robotic mower will automatically return to the charging station by
following the boundary wire anti-clockwise. After a full recharge, your robot will start
again with its next cutting sequence (if within your set worktime window).
Pay attention to protect the extension cable!
Install the charging station on a horizontal surface.
Finish the layout of the boundary cable before connecting the device to the power
supply.
Preparing boundary wire for charging station
After laying the boundary wire you need a wire stripper to skin the wire. Expose
1 0 – 1 5 m m of the metal threads for connection to the charging station.
Connect the charging station to the boundary wire
The wire leading you to the front of the charging station must be put underneath that,
are final.
when your lawnmower battery volt-
This wire end con-
nects to "+"
20 (EN)
10-15
This wire
end con-
nects to "S1"