Programming; Control Panel - Mowox RM 750 BTU-SN Manual De Instrucciones

to work or wait for remain in the base station until the next worktime window is
reached.
3. The red LED indicator on the station indicates the battery is on charging.
4. The constant green LED indicator on the station indicates the battery is fully
charged. If in the scheduled working time, the mower will leave the station and
start the automatic working process; otherwise it will stay on the station.
If your robot mower, for some reason, cannot return to the charging station, it will
try again by returning to the lawn area and find the boundary wire, then follow the
same procedure.
If the battery temperature is higher than 45° C, the device will stop charging to
protect the battery. After the temperature has been reduced, charging will automat-
ically restore.
If the mower system control board temperature is higher than 90° C, the robotic
mower will stop work, and go back to charging station. After the temperature has
been reduced, the work process will restore according your settings.
If the battery power is fully consumed while the device has not driven to the charg-
ing station, the mower cannot be started (the screen keeps off). Please take the ro-
bot back to the station and put it on the charging position; keep the main power
switch ON. The mower will be charged automatically.
In the charging station, the main
power switch has to be turned
"ON" all the time.
6. P
ROGRAMMING
6.1 C
ONTROL PANEL
The mower has already been programmed at the factory; however, you can change
these settings as required. Although the factory settings are suitable for most gar-
dens, it is still advisable to familiarize yourself with all available options.
After turning on the robot, it is locked with the factory-set PIN „1234".
Enter this PIN code by pushing one after another. Confirm with
25 (EN)
OFF
ON