Troubleshooting; Troubleshooting Of The Charging Station; Troubleshooting Of The Robotic Mower - Mowox RM 750 BTU-SN Manual De Instrucciones

ONLY USE ORIGINAL MANUFACTURER REPLACEMENT BAT-
10. T
ROUBLESHOOTING
10.1 T
ROUBLESHOOTING OF THE CHARGING STATION
LED
off
constant
green light
flashing green
red
10.2 T
ROUBLESHOOTING OF THE ROBOTIC MOWER
Indicator codes
Warning LED
Flashes blue and red alternatingly.
Continuous blue.
Continuous red.
Flashes red 1x per second.
Flashes blue 1x per second.
Flashes blue 2x per second.
Flashes blue 3x per second.
Please note that all error indicators will be deleted after 2 minutes when the device
enters standby mode. If you find the device standing outside the base and turned off,
it will not be able to show you the error by LED signals. Bring it back to the station.
Note that the most common source of failure is the incorrectly installed boundary
description
no power
ready for mowing (Battery fully
charged, boundary wire OK)
boundary cut off or connected
wrongly
battery on charging
TERIES.
Change the two wire ends and
check if the boundary wire has
Await full charge or set "Start" –
Error
Robot outside the boundary wire.
Obstacle sensor triggered 5* consecutively.
Lift sensor 5 * triggered consecutively.
Position sensor continuously triggered.
Motor current consumption too high
Main PCB error.
Too strong discharge of battery.
41 (EN)
solution
Check power supply.
correct connection
a break somewhere.
"OK".