Cutting And Heading Home; Battery - Mowox RM 750 BTU-SN Manual De Instrucciones

PIN input. Press for 5 seconds to turn the ultrasonic sensors on/off.
6.2 C
UTTING AND HEADING HOME
1. Set the main interruption switch to "ON" position (inwards).
2. Press the operating button. The lock indicator and the power indicator light up
red - the battery and warning icon flash alternately. After 4 seconds, the battery
icon, the lock indicator and the power indicator will continuously light up. The
robotic mower is then ready for operation.
3. Before operating the robot, you have got to enter the correct unlock code. The
factory-set PIN is
. Confirm with
green.
4. If you enter an incorrect PIN, the lock indicator and the power indicator will flash
red. Simply re-enter the PIN.
5. Press the lock button if you want to lock the control panel. The robot does this
automatically after 5 seconds without a keyboard input. In this case, repeat step
2.
6. Push
7. If the battery capacity is over 30%, the LED battery indicator is continuously
green.
8. If the battery capacity is less than 30%, the battery indicator lights up red and the
robot automatically returns to the charging station to charge the battery. If the
preselected time interval has not yet expired after recharging the battery, it goes
out to mow again.
9. Hit the „STOP" button to stop operation immediately.
10. Push
The PIN must be entered before a command.
Each input must be confirmed with
The displayed time program is performed and repeated at the
Each intermediate input resets this start time.
6.3 B
ATTERY
„1-2-3-4". Slowly and subsequently press
. The keyboard is unlocked and the lock LED lights up
& ; the robot starts its operation.
and ; the robot follows he boundary wire tot her charging station.
same time every day.
Battery is fully charged.
Battery capacity around 30% remaining.
27 (EN)
(double opt-in).