Mowox RM 750 BTU-SN Manual De Instrucciones página 453

problem message on
the LED
The robotic Error LED
mower blue flash-
stopped in ing (1 / sec-
the grass. ond)
The robotic Error LED
mower flashes blue
doesn't start and red al-
ternatingly
The robotic Error LED
mower can- blue flash-
not start or ing (3/sec-
stops and ond)
turns off.
The robotic -
mower goes
back to the
station and
stays there,
although it's
the sched-
uled working
time.
possible reason
The robotic mower
stopped because of
too high current in the
motor: Blockage or de-
fect.
The robotic mower is
outside the working
area.
The boundary wire is
wrongly connected or
cut-off.
There is no power sup-
ply.
Battery failure. This can
be caused by deep dis-
charge or a permanent
loss of capacity.
1. Rain sensor triggers.
2. Battery is dis-
charged.
3. Device is overheated.
and wait to cool down.
43 (EN)
action
1. Check if too tall grass in the lawn
blocks the. If so, please cut the grass
to less than 60 mm using a conven-
tional mower.
2. Increase the cutting height.
3. Check if the blade disk is jammed. If
needed, clean.
4. Check if the wheels are jammed.
5. Restart the robotic mower or take
it back to the charging station.
1. Make sure the robotic mower is in
the working area.
2. Check if the LED indicator on the
charging station is constant green.
3. If the Robotic mower runs outside
of the boundary at one spot several
times, please check if there is a high-
voltage cable nearby or underneath.
Change the position of the boundary
wire.
4. If the robotic mower runs outside
of the boundary on a slope, avoid
that area by changing the position of
the boundary wire.
5. Restart the robotic mower or take
it to the charging station.
Turn off the robot, bring it into the
station and turn it back on. Wait three
hours.
If the problem persists, the battery
has reached the end of its life.
1. In case of rain, the robot returns to
the position, as no good mowing re-
sult is expected and the wheels on wet
grass have too little traction for mow-
ing.
2. Leave the robot in the station for 3
hours without input. If the problem
persists, the battery is at the end of
its life and must be replaced.
3.Above 45°C, the battery will not be
charged. At even higher tempera-
tures, the device waits for cooling in
the base station. In this case, put the
base station in the shade, e.g. by
means of a robot garage.