Preparing For Charging; Charger Set-Up Location - Fronius Acctiva Seller Manual De Instrucciones

Ocultar thumbs Ver también para Acctiva Seller:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 63
2
3
4
5
6
7
8
Preparing for
1
charging
2
3
4
5
6
Charger set-up
1
location
2
3
4
5
42
Complete eye protection and protective clothing must be worn. Do not touch
your eyes when working in the vicinity of a lead acid battery
If skin or clothing comes into contact with battery acid, wash the acid
immediately with soap and water. If acid gets into the eye, rinse the eye
immediately with running cold water for at least 10 minutes and seek
immediate medical assistance.
NEVER smoke or allow sparks or naked flames close to the battery or engine
Be especially careful to avoid the risk of a metal tool falling onto the battery.
This might create sparks or short-circuit the battery or other electrical com-
ponents, thereby causing an explosion.
Remove personal metal objects such as rings, bracelets, necklaces and wat-
ches before working with a lead acid battery. A lead acid battery can cause a
short-circuit current high enough to melt a ring or similar, thereby leading to
a fire.
Use the charger only to charge a LEAD ACID battery. It is not suitable for
transferring power to an electrical low-voltage system other than a starter
motor application. Do not use the charger to charge dry cell batteries, which
are used mainly for home appliances. Such batteries can burst, causing injury
to people and damage to property
NEVER charge a frozen battery
If it is necessary to remove the battery before charging, always detach the
earth connection first. Make sure all vehicle equipment is switched off to pre-
vent arcing
Ensure that the area around the battery is well-ventilated while the battery is
being charged. The released gas can be effectively dispersed using a piece of
cardboard or other non-metallic object such as a fan
Clean the battery terminals. Be careful to ensure that corrosion residues do
not come into contact with the eyes
Top up each cell with distilled water until the battery acid reaches the level
specified by the manufacturer. This helps to purge surplus gas out of the
cells. Do not overfill. In the case of a battery without cell caps, follow the
manufacturer's charging instructions carefully
Study all battery-manufacturer-specific safety precautions, such as the re-
moval or non-removal of cells caps during charging and the recommended
charging parameters
With the help of the vehicle manual, determine the battery voltage and ensu-
re that it matches the output of the charger
Place the charger as far away from the battery as the cables will allow
Never place the charger directly above the battery being charged; battery ga-
ses may corrode and ruin the charger
When measuring acid density or topping up the battery, never allow battery
acid to drip onto the charger
Do not operate the charger in an enclosed area or where there is limited ven-
tilation
Do not place the battery on the charger

Publicidad

Tabla de contenido
loading

Tabla de contenido