Spo Sensor Connection - Gima VITAL PRO-SNET Manual Del Usuario

The symbol indicates that the cable and accessories are designed to have special protection against electric
shocks, and is defibrillator proof.
3.4.3 SpO Sensor Connection
2
The SpO sensor is very delicate. Please follow the steps and procedures below when useing it as failure to do so
2
correctly can cause damage to the SpO
Operation procedure:
1. Connect the SpO
the head of the connector and pull it out.
2. If the finger clip SpO
finger with short nail length) as shown in the figure below.
When selecting a sensor, consider the patient's category, adequacy of perfusion, availability of probe site and anticipated
monitoring duration. Use only SpO
SpO probe information. Refer to Chapter 11.5 for the detailed instructions of each SpO
2
SpO
SpO
SpO
SpO
3. If the neonate SpO
Y type sensor
sensor.
2
sensor to the connector labeled "SpO
2
sensor is used, insert one finger into the sensor (index finger, middle finger or ring
2
Figure 3.9 Finger clip SpO
probes provided by our company with this monitor. Read the following table for
2
Probe
2
Finger Clip Sensor (reusable)
2
Finger Rubber Sensor(reusable)
2
Finger Clip Sensor(reusable)
2
sensor is used, please follow Figure 3.10 to connect.
2
". When unplugging the probe, be sure to hold
2
sensor placement
2
Patient Category
Pediatric
Adult
Adult
Sensor adapter: wrap
15
probe.
2