Angelo Po 1N1PI1G Manual De Uso página 104

The nameplate shown here is fi tted directly to
the appliance. It contains references and all es-
sential information for operating safety.
Extra nameplate
A)
a 1 ) Country of use
a 2 ) Appliance category
a 3 ) Type of gas
a 4 ) Gas pressure
a 5 ) Type of fume exhaust vent
B) Nameplate
b 1 ) Appliance model
b 2 ) Type of customisation
b 3 ) Manufacturer identifi cation
b 4 ) Serial number
b 5 ) Protection class
b 6 ) EC conformity mark
b 7 ) Reference standard
b 8 ) EC certifi cate number
b 9 ) Product family type
b 10 ) Type of gas
b 11 ) Rated power (kW)
GB
For all requirements contact the agents or the he-
adquarters of Angelo Po which can be found in
the contacts section of the website http://www.
angelopo.com.
When requesting service, state the data provide
on the nameplate and provide a description of
the fault.
3320160_inst_GB_rev.1
IDENTIFICATION OF MANUFACTURER AND APPLIANCE
PROCEDURE FOR REQUESTING SERVICE
b 12 ) Gas consumption
b 13 ) Testing gas indicator frame
b 14 ) Voltage (V)
b 15 ) Frequency (Hz)
b 16 ) Electricity power consumption (W)
b 17 ) Test voltage indicator
b 18 ) Date of construction
C) Testing gas plate
c 1 ) Type of gas
c 2 ) Gas pressure
The installer must select the plate (A) and ap-
ply it alongside the nameplate relating to the
country of use, and must mark the relative ap-
pliance class (Type A = standard fume exhaust
vent).
If the appliance is to be used with the same
type of gas as used by the manufacturer for
testing, the installer has to remove the plate
(C) and apply the indicator (b13) against the
data of the gas for use on the nameplate.
- 4 -
ENGLISH