Descargar Imprimir esta página

Angelo Po 1N1PI1G Manual De Uso página 18

Marmita indirecta “gas”

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Importante
Important
Make a daily check that the safety devices
are properly installed and in good working
order.
Important
Importante
At the end of every cooking session, af-
ter having emptied out the tank, be sure to
switch off the pilot light by placing the burn-
er control knob on "0".
Caution - Warning
The fl oor, near the appliance, could be slip-
pery.
Importante
Important
The necessary connections (water, electricity
and gas) must be set up exclusively by suita-
bly specialised staff , in accordance with local
requirements.
Important
Importante
Do not dump pollutant material in the en-
vironment. Dispose of it in compliance with
the relevant laws.
Caution - Warning
Never use the appliance with no water in the
well, as this may damage its structure.
Important
Importante
Before carrying out any servicing procedure,
activate all the safety devices provided and
decide whether staff at work and those in the
vicinity should be informed.
Important
Importante
Before starting any cleaning operation, al-
ways turn off the gas supply tap, cut off the
electricity supply using the master switch
and allow the appliance to cool.
Caution - Warning
When using detergents, rubber gloves, pro-
tective mask and safety goggles must be
worn in accordance with the relevant safety
regulations.
Caution - Warning
Never use products containing substances
harmful or hazardous for health (solvents,
petroleum spirits, etc.).
Caution - Warning
Before doing any work, cut off the mains
electricity supply.
Important
Importante
Before it is put into service, the system must
be tested to check the operating conditions
of every single component and identify any
malfunctions. In this stage, it is important to
check that all health and safety requirements
have been complied with in full.
Importante
Important
Prima di eff ettuare qualsiasi tipo di regolazi-
one, attivare tutti i dispositivi di sicurezza
previsti e valutare se sia necessario infor-
mare adeguatamente il personale che opera
e quello nelle vicinanze.
Important
Importante
Prima di eff ettuare qualsiasi intervento di
sostituzione, attivare tutti i dispositivi di
sicurezza previsti e valutare la necessità di in-
formare adeguatamente il personale che op-
era e quello nelle vicinanze.
Caution - Warning
Do not obstruct the fl ue to avoid the tem-
perature of the combustion components and
products from increasing excessively over
the admissible limits.

Publicidad

loading

Este manual también es adecuado para:

1t1pi1g1n1pi2g1t1pi2g1n1pi1ga1t1pi1ga1n1pi2ga